52v Panasonic 11.5ah or 13.5ah E-Bike Bottle Battery
- 14s4p = 56GenuinePanasonic18650 cells (see breakdown on 18650 cells)
- 52 volts
- 11.5ah or 14ah depending on cell choice
- 600 or 700 watt hours
- 30 amp output
- Only 7.5 pounds
- Life Expectancy 500-1000 charges
- Dimensions: 15.5 x 3.5 inches (just battery) 17.5 x 4.25 inches with mount
- Made up of some of the finest battery cells in the industry (Panasonic Pf or Panasonic GA)
- Amazing power density in small size pack
- Enough power for most kits
- On/off Switch
- Battery meter tells you how much charge is left
- Battery locks into place with key lock
- Battery is easily removable and swappable
- Aluminum Case to protect battery
This isn't your ordinaryChinesemade bottle pack. True, we started with the highest qualityChinese bottle case on the market, and then filled it full with 56 of the highest quality 18650 cells available. You can choose either the Panasonic PF for high power or the Panasonic GA . These are the same 2 cells that Tesla chose for most of their battery packs.
This pack is built into a bottle shapebottle, designed to fit where the water bottle would go for an ultra clean installation inside your triangle. This will give your bike an expensive commercial ebike look to it. The bracket easily mounts to your frame either with existing water bottle holes or you cansimply drill some. Threaded holes or usezip ties. Your pack slides in and out of the bracket with a quick release so you can charge your battery on the bike or off the bike. It also has a key switch for locking the pack to the bike so you don't have to worry about theft. It also has an on-off switch which is nice onan electric bike.
Look at this article for example of how elegant a mounting solution a bottle pack like this can be. (read article here)
If you kit or controller puts out 30amps we really recommend you go with the PF cell. The GA pack should just be for users who desire more range.
This pack comes with a very advanced BMS (batterymanagementsystem) which protects the pack from damage during charge and discharge. This BMS also hastemperatureprotection to keep the pack from getting too hot during discharge and charging. (read ourarticleon BMS)
Regarding mounting / Compatibility
This is a long pack (15 inches), and will fit on most hard tail frames, as long as they are not small in size on the standard downtube position using the regular water bottle mount screw holes. (see pictures for example) For smaller sized packs look at our 48 volt bottle packs, and our shark packs both in 48 and 52 volts.
This bottle battery may be too long for some bikes so may need to be mounted in a different place like on the toptube or even on a rear rack. You can zip tie the mounting bracket to the bike in any position, or you can tap screw holes for the ultimate solution if you cannot use or do not have water bottle mounting screw holes.
This is a 30amp continuous amp pack with 60amp bursts which should be compatible with just about any ebike kit. Do not worry if its more amperage than you need because your controller will only sip the amps it needs. However make sure your controller is compatible with a 52 volt battery. Most 48 volt ebike controllers will work with slightly higher 52 volt pack and you will get up to 20 percent more power out of the same amperage (watts is equal to volts times amperage). Read article on the benefit of 52 volts
Go with the Panasonic PF 11.5 ah cells if you need 30A continuous only choose the Panasonic GA 14ah if you desire more range.
Please note - All lithium batteries must be shipped by a certified hazmat carrier (usually Fedex or UPS). The hazmat fee for batteries is between $40-60 depending on region of country. The cost of shipping to you will be calculated at checkout.